HID: letsketch: fix UAF on inrange_timer at driver unbind

In the Linux kernel, the following vulnerability has been resolved: HID: letsketch: fix UAF on inrange_timer at driver unbind letsketch_driver does not provide a .remove callback, but letsketch_probe() arms a per-device timer: timer_setup(&data->inrange_timer, letsketch_inrange_timeout, 0); The timer is re-armed from letsketch_raw_event() with a 100 ms timeout on every pen-in-range report, and its callback dereferences data->input_tablet to deliver a synthetic BTN_TOOL_PEN release. letsketch_data is allocated with devm_kzalloc(), and its input_dev fields are devm-allocated via letsketch_setup_input_tablet(). On device unbind (USB unplug or rmmod), the HID core runs its default teardown and devm cleanup frees both letsketch_data and the input devices. Because no .remove callback exists, nothing drains the timer first: if raw_event armed it within ~100 ms of the unbind, the pending timer fires on freed memory. This is a UAF read of data and of data->input_tablet, followed by input_report_key() / input_sync() into the freed input_dev. The same problem can occur on the probe error path: if hid_hw_start() enabled I/O on an always-poll-quirk device and then failed, raw_event may have armed the timer before devm releases data. Fix by adding a .remove callback that calls hid_hw_stop() first. hid_hw_stop() synchronously kills the URBs that deliver raw_event(), so once it returns no path can re-arm the timer. timer_shutdown_sync() then drains any in-flight callback and permanently disables further mod_timer() calls. Apply the same timer_shutdown_sync() in the probe error path so the timer is guaranteed not to outlive data.